自動扶梯建物配合技術要求：
1、按富士自動扶梯土建佈置要求進行扶梯安裝用留洞和包括安裝墊板在內的支撐樑及提升高度超過6米的中間支撐底座。
2、首層提供底坑並進行防水處理。
3、安裝自動扶梯吊裝用頂棚開孔和吊裝設備。
4、扶梯安裝後周圍建築的補修工程。
5、在扶梯進口和出口處應提供寬度不小於扶梯寬度，長度不小於2.5m的非限制區域，當寬度超過扶梯寬度2倍時，長度可縮小到2m。
6、電源配置：
扶梯上停站，提供380V、50Hz、三相四線的動電源及220V、50Hz、單相照明信號電源並設置接地線。
動力電源及照明電源應用獨立的電纜從監控室送入上機房。
7、扶梯樓層地板開口周圍應設安全防護欄杆，出入口附近如設置護欄，應採用防兒童站爬結構。
8、自動扶梯之間的間隙大於200mm時，中間防墜落安全網和自動扶梯與建築物之間間隙的防護板及防護柵欄。
9、牆壁或其他房屋結構不可壓著椼架。
10、提供安裝時的水、電源及緊急照明。
11、A temporary storage, with lock, should be furnished.
12、All “by others” works described on drawing should be down by owner.
Site requirement The following works should be down by the owner： 1.Concrete opening and steel plate on support nose. Supporter, if the rise is over 6000mm. 2.Prevention works of water penetrate for pit at lower side. 3.Ceiling opening for hoist and relative tools. 4.Site finishing after the install of escalator. 5.A cleat access area, not less than escalator width and not less than 2500mm in length, should be furnished at entering and exiting. 6.The power,220/380VAC-50/60Hz-3P-4w, 220VAC-50/60Hz-1P and earth,should be furn- ished at upper side. 7.The fence should be furnished beside the floor opening. 8.A safety net should be furnished between two adjacent escalators if the gaps are over 200mm. A guard panel should be furnished between escalators and adjacent objects. 9.Buildings should not lean against the truss. 10.Water, power and emergency lighting for installing works should be furnished. 11. 12